Hello all.
I went ahead and started a demo with a broker that allows hedging.For this test, I am using the 15m tf to make it possible for some actual trades to open since using the daily tf does not always allow for open trades.
If I am reading this area of the manual correctly:
8. Jumping stop settings: the robot can set a jumping stop based on your setting in
JumpingStopPips. Remember to adjust your settings for 4 digit criminals. This
feature is not a part of Ash's live manual strategy.
I. JumpingStop: set this to 'true' to use this feature.
II. JumpingStopPips: the number of pips the stop must jump by.
III. JumpAfterBreakevenOnly: defaults to 'true' and stops the robot from jumping
the sl until the trade is already at breakeven, which will happen at the end of the
candle if the trade is in profit.
9. Part close settings:
I. PartCloseEnabled: this addresses the part of the system that closes half the
trade at the end of the first candle in which the trade is in profit. What happens
depends on these two settings:
II. Close_Lots: the proportion of the trade to close. The robot will do this with
every new candle until the trade is left with only Preserve_Lots lots.
III. Preserve_Lots: the lot size beneath which the robot will not close any more of
the trade.
IV. AutoCalculatePartClose: set this to true to tell the robot to calculate 50% of a
successful open trade to close at the end of the candle. This figure will grow with
the growing lot size if the robot is also automatically calculating the lot sizes.
This will only function if enabled when the trade is sent; sending a trade and
then setting this to true will not work. PartCloseEnabled must be true for this
function to work.
I would think this would apply to the audjpy trade in the attached? I do have
jumpingstop pips as 50.
jump.gif
test.doc
Just checked the audjpy trade that was at +117 pips in the attached.It is now at -89 pips.I must have something not set correctly?
Have a nice weekend all.
Vince
